Home / Blog / How to fix an advertising banner

How to fix an advertising banner

A poorly fixed banner lasts a season, a well-fixed banner lasts several. The fixing method is decided before ordering, because it determines the finish to be applied to the canvas.

The rule: distribute the tension

A banner almost never fails in the middle. It tears where tension concentrates: an isolated eyelet, a corner, an unreinforced edge. The whole art lies in distributing the load around the entire perimeter.

1. Eyelets and bungee cords: the universal fixing

Thehem doubles the canvas along the edge, theeyelet is crimped into it every 50 cm. You thread a bungee cord, an elastic bungee cord with hook. Its elasticity is its advantage: it absorbs wind gusts instead of transferring them to the banner. It is the solution for fences, barriers, building facades and structures.

Avoid rigid cable ties on an exposed banner: without elasticity, the eyelet takes the strain.

2. Pole pockets and tubes: the tensioned banner

The pole pocket is a sleeve sewn or welded at the top and bottom of the banner. A tube is slid inside: the fabric stretches taut and straight, without creases. This is the finishing used for suspended banners, hanging banners and banners mounted on a pole. A tube of weighting in the bottom pole pocket keeps the banner straight.

3. Velcro: on a structure

The velcro is sewn onto the edge of the banner and attaches to a strip fitted to the frame. It is used for exhibition stands, counters and demountable frames, when the graphic needs to be changed quickly.

4. Keder: in a slide-in frame

The keder is a bead welded to the edge of the canvas, which slides into the groove of an extrusion. The banner is held along its entire length: this is the neatest fixing for a frame or a sign.

Depending on your substrate

  • Fence, wire mesh, barrier : hems, eyelets, bungee cords. On windy sites, fabric micro-perforated.
  • Façade : eyelets around the perimeter and wall screw eyes, or keder frame.
  • Between two posts : top and bottom pole pockets, or eyelets and bungee cords.
  • Exhibition stands : Velcro or pole pockets.

Three frequent mistakes

  • Ordering a banner without finishing for outdoor use.
  • Only fastening the four corners of a large format.
  • Tensioning too tightly: a banner must be able to flex slightly.

On a very large format, a reinforcement strip extends the life of the edges. All these finishes can be selected on the product page, from the advertising banner.

Related articles

All blog articles